A range of foam mattress replacements, designed for pressure reduction and comfort. Different zones of the mattress offer either pressure reduction or support. The mattresses have a two way stretch cover. Four models are available with varying support. Available in single bed sizes. Sizes can be customised on request.
1) Integriderm 9500 - Specialty mattress designed for critical care needs. Two level construction. Has 'heel ease' / leg raise feature. The middle foam layer can be rolled up to provide a raised section 50mm above the ankles.
Cover features a covered zipper (flap over zipper). Sealed unit is available on request.
2) Integriderm 9000 - Fully sealed. Four layer foam construction
3) Integriderm 8000 - Fully sealed. Four layer passive restraint mattress with a safety rail design
4) Integriderm 6000 - Fully sealed. Three layer foam construction
| Specification | MP5000 | MP6000 | MP9000 | MP9500 |
|---|---|---|---|---|
| Height | 127 mm | 152 mm | 177 mm | 203 mm |
| Length | 1980 mm | 1980 mm | 1980 mm | 1980 mm |
| Load Capacity (supplier stated) | Unknown | Unknown | Unknown | Unknown |
| Weight (kg) | Unknown | Unknown | Unknown | Unknown |
| Width | 850 mm | 850 mm | 850 mm | 850 mm |
Mattress
. Made of resilient foam with a contoured surface.
. The mattress has alternating 'support' and 'reduction' zones. Five zones reduce interface pressure. Two zones provide essential support.
. Increased support is provided around the mattress edge.
. Filtered Air Flow. Air flow in and out of the mattress is protected by filters - eliminating 99.5% of airborne bacteria. An impermeable shield guards the filter against moisture.
Cover
. The cover has two way stretch, is water resistant, is breathable (vapour permeable), antibacterial and anti static. Has sealed seams on 9000, 6000, 5000 models.
. A foam mattress may not be suitable for use with an electric blanket. Check with supplier before purchasing.
. All pressure reduction products must be monitored to prevent 'bottoming out'. This occurs when the user's weight bears down so hard on the product material that it is flattened and the bony parts are pressed against the surface below the cushion or mattress. Where bottoming
out occurs even with correct use (e.g. correct inflation levels), a different product may need to be considered.
. Ensure that the item is not accidentally placed upside down or back to front.
Dispose of foam products if they are wet, contaminated or become deformed or misshapen.
Some assistive technology needs to meet Australian or other standards. Standards may relate to materials, manufacturing and installation. Products that meet Australian or international standards will have written certification. To find out if a product meets Australian Standards ask the supplier to show you the certificate. For a fact sheet about standards contact us or visit www.ilcaustralia.org/home/standards.asp
USA