Models And Options

Options

Baskets
- seat and rear pole mount

Rear Mounted
- golf bag holder
- crutches holder
- walking frame holder
- oxygen cylinder holder
- trailer with lockable lid

General Accessories
- walking stick clips
- sun canopy
- tarp cover for storage

Models

778ER (778E)

Dimensions

Additional Info

More Details

FRAME
This scooter has an epoxy coated steel frame, moulded plastic cowlings, rubber protection strip at the front of the base and carpeted matting on the foot platform.

SEAT
. Seat swivel lever is located underneath the front (right hand side) of the seat base and allows the seat to swivel through 180 degrees, locking at 0, 45 and 90 degrees.
. Seat height is adjustable by releasing the seat swivel lever and turning the seat to a non locked position and lifting it off. Then removing the pin and large grip screw located in the seat post. Seat height is changed and seat replaced.
. A sliding seat mechanism, activated by turning a lever under the front of the seat, allows the driver to alter seat position while seated.
. Armrests pivot up and down and are width adjustable.
. Different seat sizes are available.

STEERING COLUMN
can be tilt adjusted to three positions and is controlled via a plastic coated handle at the base of the steering column.

FRONT WHEELS
260mm pneumatic tyres

REAR WHEELS
260mm pneumatic tyres

FREEWHEELING
The scooter can be free wheeled by lifting a lever located at the rear of the base.

BATTERY CHARGING
is achieved by connecting the scooter to a separate charger and then to a mains power point. The charger point is located at the top of the steering column.

BATTERIES
are stored in separate boxes with carry straps under the seat. The scooter is powered by two 28 amp wet batteries which are housed under the seat.

FOOTREST
is a flat platform between the steering column and battery cover. The platform beside the steering column (on either side) is angled upwards.

CONTROLS
Delta tiller with finger operated acceleration and reverse controls (proportional speed controls). Includes a key for turning the scooter on and off. The LED meter indicates the amount of proportional charge left in the batteries. The controller also features a dial to select from a range of 10 speed settings; push button horn and lights; and an battery LED battery level indicator.

BRAKES
are electromagnetic

Factors To Consider

Overall length.............1150mm
Overall width..............600mm
The space allowed on public transport for carrying mobility equipment is an area of 1300mm by 800mm.

Setup And Maintenance

Maintenance

Refer to supplier / manufacturer manual for maintenance details and safety warnings.

Requirements

Licence & Insurance Requirements

Registration requirements
In NSW, motorised wheelchairs that weigh less than 110 kg and cannot travel at more than 10 km/h do not have to be registered, provided they are being used by a person with mobility problems. A person driving a motorised wheelchair under these circumstances is defined as a pedestrian under the Australian Road Rules and is permitted to travel on a footpath or nature strip adjacent to the road.

Vehicles exempt from registration are covered by the nominal defendant scheme (administered by the Motor Accidents Authority) if they are at fault in an accident in NSW on a road or road-related area and cause injury to another person. However, this cover is only valid in NSW.

Standards

For some types of equipment, specific Australian or other Standard(s) are applicable to the materials used in, the manufacturing processes applied to and the installation of products. Compliance with relevant Standards is indicated by written certification that a product has been tested and assessed as compliant with specified Standards. Purchasers are advised to check with the supplier or manufacturer of this item as to its compliance with relevant Standard(s).

Place Of Manufacture

Taiwan