Models And Options

Options

Right angle entry / exit models are available.
Call stations on upper and lower levels
Anti entrapment walls
Heavier lift capacity and/or larger deck sizes are available.
Remote control option.

Models

Various models are available

Additional Info

More Details

Method of lift operation: constant pressure, hold to run control.
Method of door operation: automatic opening door.
Accessibility of control panel within the lift: The platform has an easy to use control panel with constant pressure buttons at a wheelchair accessible height.
Safety Features:
- Anti entrapment system,
- Emergency stop,
- Under deck protection system,
- Automatic fold up ramp fitted to entry and end of deck prevents any likely wheelchair roll off,
- Safety gate fitted to all lifts as standard,
- Body side handrail is designed so that the user can slide their hand unobstructed past the body work,
- Back up battery.

Control Panel: designed to make the controls simple to operate
Security Key - When the key is in the off position the lift is immobilised
Up Button - When this button is depressed the lift will rise to its preset height.
Down button - When this button is depressed the lift will travel to the ground.
Emergency stop - If this button is pressed in, the lift will instantly stop.
Power off operation: In the event of mains power failure the lift can complete 20 raise and lower operations due to back up battery.

Setup And Maintenance

Installation

In NSW the owner or controller of the lift (if not the owner) is required to register their lift with WorkCover. They need to complete Form PL2 Application For Item Registration of Lift / Escalator and Moving Walkway. A fee of $65 is charged for a lift installed in a public place. The applicant must state that the plant has been inspected by a competent person and is safe to operate (use).

It is compulsory that the lift be inspected annually by a competant person. WorkCover requires payment for registration as well as an annual fee.

Request further details from the supplier or contact WorkCover Plant Registration Unit.

It is an offence to operate plant that is not correctly registered under the Occupational Health and Safety Regulation 2001.

Requirements

Standards

Specific Australian Standards or other Standard(s) may be applicable for materials, manufacturing processes, or installation of some types of equipment. Compliance with relevant Standards is indicated by written certification that a product has been tested and assessed as compliant with specific Standards. Purchasers are advised to check with the supplier or manufacturer of this item as to its compliance with relevant Standard(s).

This lift complies with AS 1735.14

Relevant Australian Standards for this Category
AS 1735 Part 14 1998

Place Of Manufacture

NZ