iWALKFree is a hands free crutch designed to meet the mobility needs of people with non weight bearing lower leg injuries. The device supports the knee and upper leg using a universal, ambidextrous fastening system that allows for almost any adjustment for user height and leg size. NOTE: This crutch is for people with good balance. It is strongly recommended that the device be adjusted by an accredited physiotherapist or orthopaedic technologist prior to its initial use.
Wearing iWALKFree:
* Place knee of affected leg on tray; fasten tray strap to a snug, comfortable fit
* Fasten lower strap to a snug, comfortable fit around leg just above knee
* Fasten upper strap to a snug, comfortable fit around leg just below groin
Walking with iWALKFree:
* Use either a handrail or parallel bars while becoming accustomed to the device
. maintain a wide stance with legs apart while walking
. maintain an erect posture and watch where you are going
One model is available
| Specification | Standard |
|---|---|
| Height | Unknown |
| Load Capacity (supplier stated) | Unknown |
| Weight (kg) | Unknown |
iWALKFree is an alternative to traditional crutches, allowing its users:
- self-sufficiency through the full use of their arms and hands
- increased opportunity to take an active part in their lives and their rehabilitation
Product Design
The Crutch has been designed to be comfortable, lightweight, and compact. It is fully adjustable to meet the needs of adults and young people of varying height.
iWALKFree is constructed of UV resistant and hypoallergenic materials, and comprises 4 simple parts:
. one stable beam with tread
. one supportive locking tray with strap
. two comfortable padded straps with integral cam clips
To assemble and fit iWALKFree:
. trim the beam to equal the inseam measurement
. with the user seated with leg bent at a 90-degree angle, measure the distance from the back of knee to the ground of the unaffected limb. This determines the height for the top of the tray
. to attach the tray, unlock the front cam clip; disengage locking pin; slide tray onto the beam; lock pins; lock cam clip at the front of the tray
. to attach the straps*, unlock cam clip of lower strap; slide onto beam just above knee; lock cam clip; repeat with upper strap; slide onto beam just below groin; lock cam clip
. install beam cap
*all straps can be flipped for right or left handed use
To Check for Proper Fit:
When walking with iWALKFree, the user should be able to swing their leg freely front to back without catching it on the ground. If the leg can't move freely, then iWALKFree is too long, and needs to be readjusted
USA
Some assistive technology needs to meet Australian or other standards. Standards may relate to materials, manufacturing and installation. Products that meet Australian or international standards will have written certification. To find out if a product meets Australian Standards ask the supplier to show you the certificate. For a fact sheet about standards contact us or visit www.ilcaustralia.org/home/standards.asp