Short Description

Two indoor stairlift models with a wheelchair platform. Cama Handi-lift 7 is for straight staircases. Cama Handi-lift 6 is for curved staircases including landings. Lifts are built individually with regard to the width and length of the staircase. If this lift is to be used in a public building it must comply with the relevant Australian Standard. Contact the supplier for details.

Models

TYPE 6
. Drives in the stairs inner curve. Can turn 90 and 180 degrees and drive across a landing
. Battery powered
. Can be changed from right to left side

TYPE 7
. Electrically powered
. Rack & pinion drive
. Fits to wall or columns

More Details

. Folding platform
. Aluminium wall mounted rail system
. Safety arms and flaps which lift up when platform is in motion

Safety features:
. Overspeed governor and brake
. Pressure sensitive surfaces which stop the lift when it runs into an obstacle
. Limit switch
. Thermal overload relay
. Manual release mechanism

Installation

In NSW the owner or controller of the lift (if not the owner) is required to register their lift with WorkCover. They need to complete Form PL2 Application For Item Registration of Lift / Escalator and Moving Walkway. A fee of $65 is charged for a lift installed in a public place. The applicant must state that the plant has been inspected by a competent person and is safe to operate (use).

It is compulsory that the lift be inspected annually by a competent person. WorkCover requires payment for registration as well as an annual fee.

Request further details from the supplier or contact WorkCover Plant Registration Unit Tel: 02 9370 5221. If outside the Sydney metropolitan area, phone the WorkCover NSW Client Contact Centre on 13 10 50 or the nearest WorkCover Regional Office.

It is an offence to operate plant that is not correctly registered under the Occupational Health and Safety Regulation 2001.

Place Of Manufacture

Denmark

Standards

For some types of equipment, specific Australian Standard(s) are applicable to the materials used in, the manufacturing processes applied to and the installation of products. Compliance with relevant Standards is indicated by written certification that a product has been tested and assessed as compliant with specified Australian Standards. Purchasers are advised to check with the supplier or manufacturer of this item as to its compliance with relevant Australian Standard(s).