Short Description

This Canine Convulsion / Epilepsy Alarm System has been designed to provide an alarm when an epilepsy episode in a dog is detected. The alarm consists of an alarm unit with power pack and a vibration detector.
A vibration sensor is placed on the chest of the dog attached to a walking harness. It registers the commencement of a seizure after a short time delay and initiates an alarm which can be either audible, vibratory or visual (flashing light).

Models

Only one model is available

More Details

. The alarm will work on dogs from the size of a beagle.
. It is suitable for the monitoring of epilepsy where convulsions are associated with the attack.
. The system enables a seizure to be notified to the owner within 20 to 30 seconds of the onset of the seizure.
. The alarm unit has an in built time delay that can be adjusted from about 1 second to 45 seconds before the alarm is activated.
. The alarm is suitable for owners who are hearing impaired.
. It can be modified to incorporate a pager system, which can have either an audible or vibration alarm indication.
. It can also be connected to an auto dialing system, which can call either a telephone pager, mobile phone or friends of the owner.
. The convulsion sensing system has no wires or long cables.
. The alarm is designed so that the audible alarm can be placed near where the owner is sleeping and it is activated by a radio signal from the vibration detector which is located on the chest of the dog.
. Depending on the alarm output required, additional add on devices can be supplied with this alarm unit.

SPECIFICATIONS
Radio transmission by coded radio signal.
Convulsion sensor powered by 9 volt lithium battery.
Low voltage (12 volt) operation of the alarm unit
Can interface into a number of alarm systems.

Installation

Simple installation required.
Complete installation information is supplied with the alarm.

Standards

For some types of equipment, specific Australian or other Standard(s) are applicable to the materials used in, the manufacturing processes applied to and the installation of products. Compliance with relevant Standards is indicated by written certification that a product has been tested and assessed as compliant with specific Standards. Purchasers are advised to check with the supplier or manufacturer of this item as to its compliance with relevant Standard (s).

Place Of Manufacture

DCT Associates (SA) Australia