A rear wheel drive scooter with three wheels and a short wheel base that can be folded or dismantles for transportation. Designed for outdoor use. Features finger operated controls; a padded seat and an option of either an in built or separate charger. Available in one model only. Unable to be customised. Some accessories are available.
* crutch holder
| Specification | Standard |
|---|---|
| Backrest Height | 400 mm |
| Base Height (clearance) | Unknown |
| Length | 1390 mm |
| Load Capacity (supplier stated) | 136 kg |
| Seat Depth | 460 mm |
| Seat Width | 460 mm |
| Weight (kg) | 64 kg |
| Weight of Heaviest Part | 23 kg |
| Width | 610 mm |
Height 970 mm
Battery Weight 9.5 kg each
Front Frame Weight 22 kg
Rear Frame Weight 23 kg
Folded Length 600mm
Frame
Epoxy coated steel frame, with plastic sections.
Seat
Fixed (not adjustable)
Steering Column
Can be tilt adjusted
Front Wheels
320mm tyres
Rear Wheels
320mm tyres
Batteries
The scooter is powered by two 12 volt 26 amp/hr deep cycle wet batteries which are housed, along with the built in charger, behind the seat. They are stored in separate boxes with a plastic handle behind the seat.
Battery Charging
This is achieved by connecting the scooter from the rear charger inlet to a mains power point. Also can have the option of on-board charging.
Footrest
Flat platform between the steering column and base of seat.
Controls
The controller features a speed reduction switch and an on/off key switch.
With head and tail lights, front & rear indicators, hazard lights switch, side and rear reflectors.
Brakes
Electromagnetic.
Dismantling
The scooter can be dismantled into three parts for transport
Standard accessories
Rear basket
A licence is not required for a rider in an exempt motor chair (electric wheelchair or scooter) which is limited to a maximum speed of 10km/h. The rider is considered a pedestrian and road rules apply as for pedestrians.
For further information contact the Independent Living Centre or the Vehicle Safety Branch, Department of Transport.
For some types of equipment, specific Australian Standards are applicable to the materials used in, and the manufacturing and installation of products. Compliance with relevant Standards is indicated by written certification that a product has been tested and assessed as compliant with specified Australian Standards. Purchasers are advised to check with the supplier or manufacturer of an item as to its compliance with the relevant Australian Standard(s).