Short Description
A mobile battery operated patient lifter which may be used to lift and transfer persons from a seated or lying position, or to or from the floor. Dismantles for transport and storage. Suitable for domestic use. Load capacity is 150kg.
Specification |
Standard |
Base Height (clearance) |
Unknown |
Base Length |
1150 mm |
Base Width Maximum (int measurement open) |
900 mm |
Base Width Minimum (ext measurement closed) |
670 mm |
Height |
1100 mm (mast height) |
Load Capacity (supplier stated) |
150 kg |
Spreader Bar Height |
From 430 mm to 1700 mm |
Tilting Frame Height |
Unknown |
Weight of Heaviest Part |
Unknown |
Additional Dimensions
Weight (kg) NSW................................... 37 kg
Speed (mm/sec).................................... 38 mm/s
More Details
* The hoist is constructed from epoxy coated rectangular steel tube.
* One piece lifting boom with a curved end, with a straight polyurethane coated spreader bar with three attachment hooks on each end.
* Widely spaced steering / push handles are mounted just below the top of the mast.
* The boom moves up and down via a hand held control on an extendable cord.* * The U shaped base is adjusted in width by a foot pedal system. The base is articulated separately from the rear castors. This allows the base width to be adjusted whilst the brakes are on.
* Castors are front and rear, with brakes on the rear castors.
* Can be used in conjunction with the Kerry Equipment range of slings.
Castors
Swivel style with dual 75mm diameter castors on the front and 125mm castors with lock on brakes on the back.
Dismantling
The hoist is dismantled by removing the mast from the base.
Powered Controls
Controls are hand held on an extendable cord. There is a hook on the hand piece to enable it to be located on the hoist when not in use.
Safety Features
There is an emergency stop and lower button located on top of the motor casing.
There is an automatic cut out switch in the event of the boom encountering any resistance
Power Source
From a battery mounted on the mast of the hoist.
Battery Recharging
Achieved by removing the battery and placing it in the supplied separate battery charger, connected to a mains power point.
Standards
For some types of equipment, specific Australian Standards are applicable to the materials used in, and the manufacturing processes applied to products. Compliance with relevant Standards is indicated by written certification that a product has been tested and assessed as compliant with specified Australian Standards. Purchasers are advised to check with the supplier or manufacturer of an item as to its compliance with the relevant Australian Standard(s)
Place Of Manufacture
Kerry Equipment (WA)
Australia