subscribers
Plastic synthetic clay which can be moulded around handles of cutlery and other household items (eg. stove, TV, knobs) to build them up. This is a permanent adaptation to cutlery. The clay is set in an oven.
Plastic synthetic clay which can be moulded around handles of cutlery and other household items (eg. stove, TV, knobs) to build them up. This is a permanent adaptation to cutlery. The clay is set in an oven.
Directions:
. The Pimbo Clay must be made pliable by working a piece in the hands for approximately 10 minutes. It can then be easily moulded around the handle of cutlery etc. to the required shape.
. Preheat the oven to 180 degrees for 5 minutes.
. Place the the article with the Pimbo Clay handle on an oven tray and cook for 10-15 minutes. If left longer than 15 minutes the clay starts to turn light brown and discolours. The clay is ready if it retains the shape when touched. If utensil cannot be put in oven, it can be set in boiling water until hard but the handle is not as strong using this method.
. Take out of oven and leave to cool or run handle under cold water.
Whilst all care is taken to provide accurate information with respect to the item described, the Independent Living Centre (ILC) is not involved in product design or manufacture, and therefore not in a position to guarantee the accuracy of the information provided. Selection of equipment, which is both suitable and appropriate for individual needs remains the responsibility of the person(s) considering requisition, and no responsibility is taken by the ILC for any loss or injury caused through use of the equipment or alleged to have arisen through reliance upon information provided. As information is subject to change any enquiries should be directed to the manufacturer.
| Supplier | Location | Contact | Website |
|---|---|---|---|
| A & M Creative Craft Materials | Bruthen, VIC | Sales: 03 5157 5687 Fax: 03 5157 5170 |
Copyright © 2009 Independent Living Centre NSW.
Site designed by the Human-Computer Interaction Laboratory, School of Computer Science and Engineering, University of New South Wales.
