Short Description
This wooden bath board is available with either four or five wooden slats that drain water away from the seating area. Two adjustable wooden blocks with metal screws are fitted under the board. These position the bath board against the sides of the bath. The board fits standard sized baths. The board has a smooth varnished finish.
Method Of Use
* Prior to using the bath board please ensure that it is correctly fitted and secure
* Sit on the edge of the bath board that is fitted to the bath
* Lift your first leg into the bath so that it is facing the tap end
* Once you have one leg in the bath and one leg outside the bath, slide yourself to the centre of the bath board and then swing your other leg across into the bath
* Do not attempt to step into the bath, and then sit down on the bath board
* Always sit on the bath board first, and then swing yourself into the bath
Models
* BTS108400 4 Slat Timber Bathboard
* BTS108600 5 Slat Timber Bathboard
Factors To Consider
* Regularly check the board for any deterioration of the wood and varnish
* Regularly check that wing nuts or screws are free moving and able to be easily adjusted
Installation
Fitting a bath board
It is important that the board fits across your bath and that your bath has a 'lip' of at least 37mm (1.5 inches) on the wall side.
Make sure that the board you choose won't overlap the edge by more than 50mm (2") of the bath as this could cause it to become unstable during use.
The board should be fitted on the bath at the end opposite the taps because taps can get in the way when you are using the board. The bath needs to be scrubbed clean so that there is not grease or soap which could make the fastenings less secure.
The boards are fixed to the bath by brackets or legs. These are adjustable - you slide them until they are wedged against the side of the bath, and then tighten them so they hold the board firmly in place. It may be easier to adjust the fixing furthest away from you first.
Always check the board is secure before using it.
Maintenance
* Regularly check the board for any deterioration of the wood and varnish
* Regularly check that wing nuts or screws are free moving and able to be easily adjusted
Place Of Manufacture
Australia
Standards
Some assistive technology needs to meet Australian or other standards. Standards may relate to materials, manufacturing and installation. Products that meet Australian or international standards will have written certification. To find out if a product meets Australian Standards ask the supplier to show you the certificate. For a fact sheet about standards contact us or visit www.ilcaustralia.org/home/standards.asp
