Short Description

A range of wall mounted fold up shower seats in a variety of styles and sizes. They are made from white acrylic. Most models have drain slots. Two models have support legs which extend to the floor. Other models do not have legs which enables them to be installed at any height. Fixing screws are included. One model (506) complies with Australian Standards.

Models

500 - 355mm wide x 315mm deep, white acrylic seat with drainage slots, no legs
501 - 450mm wide x 315mm deep, white acrylic seat with drainage slots, no legs
502 - 450mm wide x 390mm deep, white acrylic solid top, two legs
503 - 600mm wide x 390mm deep, white acrylic seat with drainage slots, two legs
504 - 600mm wide x 390mm deep, white acrylic solid top, two legs
505 - 900mm wide x 390mm deep, white acrylic seat with drainage slots, two legs
506 - 960mm wide x 390mm deep, white acrylic seat with drainage slots, two legs. Complies with AS 1428.1 2001
507 - 900mm wide x 450mm deep, white acrylic seat with drainage slots, two legs. Complies with NZS 4121

More Details

. Frame is white powder coated stainless steel. Seat is white acrylic.
. Seats with legs - legs fold up under the seat and lock in the vertical position. Either one or both legs can be made to lock. To unlock, raise the bracket slightly then fold down.
. Single slat depth is 80mm
. Gap between back of the seat and wall is 40mm (a requirement of AS 1428.1)

Installation

Installed with stainless steel screws. If installing in a public building, mounting height etc needs to meet local building code requirements.

Place Of Manufacture

Vic Australia (Hand Rail Industries)

Standards

Specific Australian Standards or other Standard(s) may be applicable for materials, manufacturing processes, or installation of some types of equipment. Compliance with relevant Standards is indicated by written certification that a product has been tested and assessed as compliant with specific Standards. Purchasers are advised to check with the supplier or manufacturer of this item as to its compliance with relevant Standard(s).

Shower seats in public buildings:
must comply with AS 1428.1 - "Design for access and mobility - Part 1: General requirements for access - new building work".

A width of 960 -1100mm is required, and depth of 390 - 400mm to comply with AS1428.1.

The fastenings, materials and construction of the seat must be able to withstand a force of 1100 N to comply with AS1428.1.