Short Description
This doorset has a two panel articulated door which folds with a concertina type action in the ratio of two thirds to one third following an elliptical curve. This reduces the swing area to approx one third of a conventional door of the same width. The Doorset is easier to open and close than a conventional door. Available in Single and Double Action in two standard sizes.
Models
Double Action Reduced Swing Door
Has been developed to pivot inwards and outwards.
Users only need to push lightly from either side to open the door.
Single Action Reduced Swing Door
Pivots in one direction only. This feature has been developed for installation where opening space is limited eg into a hallway, small room.
Doorset Handing
LH Door / RH Door
More Details
The IR Reduced Swing Doorset is a complete unit comprising a door frame and two part door leaf. The Doorset is supplied partially assembled and includes guide, track, top and bottom pivot, hinges and door seals, Draught excluders are attached to the underside of the top track.
Doorsets can operate with all types of locking / latching hardware.
Installation of lock hardware is as for typical swing doors.
Doorsets are supplied handed.
MATERIALS
Doors are construction of a golden edge skin filled with a white carbon high density polystyrene.
The door jamb is finger jointed pine.
BENEFITS
Reduces the swing area needed by a conventional door by a third
Less muscle power is required to operate the door
There is more room to negotiate a wheelchair when space is confined
SIZES
1. 900mm clear opening (excluding door furniture projection)
2. 1200mm clear opening (excluding door furniture projection)
Installation
Considerations include stud depth both sides, GIB Board used, tiling and rebated architraves. Allow at least 10mm for fitting the Door into wall cavity.
Special template is supplied on application
Note: The IR Reduced Swing Door is available as a Dry Area Unit or Wet Area Unit. If water / moisture is present each surface of the door must be sealed and / or painted prior to installation. Failure to do so may invalidate the warranty.
Standards
Specific Australian Standards or other Standard(s) may be applicable for materials, manufacturing processes, or installation of some types of equipment. Compliance with relevant Standards is indicated by written certification that a product has been tested and assessed as compliant with specific Standards. Purchasers are advised to check with the supplier or manufacturer of this item as to its compliance with relevant Standard(s).
Place Of Manufacture
Ingersol-Rand Company (Australia)