Short Description
A mobile, steel framed, battery powered hoist with a tilting frame. A spreader bar is optional. It can be used to lift and transfer persons from a seated or lying position, or to and from the floor. It is available either as a fixed model that cannot be dismantled or as a model that dismantles into four sections for transportation. The hoist has a manually operated base adjustment. Size suitable for domestic use.
Options
* Quick release connections
Models
HC15-140C
Wombat Fixed Mobile Hoist with Tilting Frame
HC15-140Y
Wombat Fixed Mobile Hoist with Spreader Bar
HC15-140C-Q
Wombat Mobile Hoist with Tilting Frame - Quick Release
| Specification |
Standard |
| Base Height (clearance) |
140 mm |
| Base Length |
980 mm |
| Base Width Maximum (int measurement open) |
1040 mm |
| Base Width Minimum (ext measurement closed) |
540 mm |
| Height |
Unknown |
| Load Capacity (supplier stated) |
140 kg |
| Spreader Bar Height |
Unknown |
| Tilting Frame Height |
Unknown |
| Weight of Heaviest Part |
Unknown |
Additional Dimensions
Weight (kg) NSW................................... 35 kg
Castor Diameter................................... 100 mm
More Details
Frame
Epoxy coated, steel
Mast
Single, upright mast. The battery is attached to the lower half of the mast.
Base
U-shaped
Boom
Single with arced angle of lift
Castors
100mm, single and swivel. Rear castors have lockable brakes.
Attachment Points
Located at four positions on the tilting frame for keyhole fittings. Two attachments are located on the optional spreader bar for sling loops.
Controls
Hand held control with push button switches for the vertical movement. Opening of the legs of the base is manually operated with a foot operated lever.
Power Source
24 volt, rechargeable battery that is situated on the lower part of the mast. An audible warning signal is activated during use when the battery is reduced to 50% of capacity.
Battery Recharging
Separate recharger. The battery is removed from the mast and connected to the battery charger at a mains power point.
Portability
One model has a removable pin in the arm of the lifter. This enables the hoist to be dismantled into four components. The mast, boom and tilting frame detach from the base.
Safety Features
Include an automatic cut out switch in the event of the boom encountering any resistance and an emergency stop and lower button on the mast.
Slings
Cradle Full Support Sling:
* Divided leg sling with padded spinal support and keyhole fittings on the straps.
* Top of sling should be level with top of users head
* Tested to 200kg
* Sizes: Small, Medium, Large, Extra Large (Colour coded)
Conventional GP slings:
* Fit standard yoke
* Available in polyester and mesh.
Standards
Specific Australian Standards or other Standard(s) may be applicable for materials, manufacturing processes, or installation of some types of equipment. Compliance with relevant Standards is indicated by written certification that a product has been tested and assessed as compliant with specific Standards. Purchasers are advised to check with the supplier or manufacturer of this item as to its compliance with relevant Standard(s).
Place Of Manufacture
SA, Australia
subscribers 
