subscribers
|
A compression stocking applicator for the leg or arm. It consists of
a triangular shaped durable paper like slippery material with a central
extended pull tab and eyelet holes on the sides for threading a thin tubular plastic lacing pin.
A compression stocking applicator for the leg or arm. It consists of
a triangular shaped durable paper like slippery material with a central
extended pull tab and eyelet holes on the sides for threading a thin tubular plastic lacing pin.
To Use:
* Fold the Eureka double so the holes on both sides match.
* Connect both sides by threading the lacing pin through the holes then insert the tip of the pin into the small pocket at the end.
* Place the Eureka over the foot with the pin side under the sole. The tab
should be over the upper foot surface.
* Pull the stocking on over the Eureka.
* Remove the lacing pin from the Eureka when the heel of the stocking is in the correct position and the remaining part of the stocking is at ankle
height.
* Pull the light blue tab to remove the Eureka from the stocking. Pull
stocking up into position.
* For pantihose - repeat instructions for the second leg.
Whilst all care is taken to provide accurate information with respect to the item described, the Independent Living Centre (ILC) is not involved in product design or manufacture, and therefore not in a position to guarantee the accuracy of the information provided. Selection of equipment, which is both suitable and appropriate for individual needs remains the responsibility of the person(s) considering requisition, and no responsibility is taken by the ILC for any loss or injury caused through use of the equipment or alleged to have arisen through reliance upon information provided. As information is subject to change any enquiries should be directed to the manufacturer.
| Supplier | Location | Contact | Website |
|---|---|---|---|
| Biomet Australia Pty Ltd | North Ryde, NSW | Sales: 02 9878 6100 Fax: 02 9878 6473 Toll Free: 1800 251 201 |
Copyright © 2009 Independent Living Centre NSW.
Site designed by the Human-Computer Interaction Laboratory, School of Computer Science and Engineering, University of New South Wales.
