Short Description
The hoist features a motorised component that allows the attendant to move the hoist and occupant via a motor in a forward or reverse direction. The boom can lower to the ground for a lift from the floor. It is available without the motorised component.
Options
* Padded vinyl calf strap
* Range of Kerry slings available
Models
Kerry Swift Drive - Product Code KH404DU
Specification |
Standard |
Base Height (clearance) |
Unknown |
Base Length |
Unknown |
Base Width Maximum (int measurement open) |
Unknown |
Base Width Minimum (ext measurement closed) |
Unknown |
Height |
1220 mm |
Load Capacity (supplier stated) |
150 kg |
Spreader Bar Height |
From 430 mm to 1700 mm |
Tilting Frame Height |
Unknown |
Weight of Heaviest Part |
Unknown |
Additional Dimensions
Weight (kg)............................... 55 kg
Length of Base............................ 1100 mm
Width of Base (closed)...................... 670 mm
Internal Width of Base (closed)..................... 510 mm
Internal Width of Base (open)....................... 885 mm
Wheel Diameter (Rear)............................. 150 mm
Castor Diameter................................... 175 mm
Speed (mm/sec).................................... From 38 mm/s to 58 mm/s
Range (km)........................................ From 10 km to 20 km
More Details
Frame Finish
* Epoxy powder coated.
* Polyurethane coating on legs of base.
* Overall finish in PVC.
Mast
Single column mast.
Drive System Operation
* Twin Lever operation.
* Pull lever towards to go forward. Push lever away to reverse hoist.
* Motor control is positioned in the centre of the drive wheel.
* On and Off switch
* Speed Control
* Motorised drive wheel is positioned in front of larger wheel at the rear of the hoist.
* When the motor is turned on and the lever pulled the drive wheel lowers and engages with the ground to drive the hoist in a forward or reverse direction.
* Drive wheel retracts upwards under cowling when not in use.
Power Supply
12X12 volt/20amp
Motor
240W / 24Volt
Battery
Plug in rechargeable battery system.
Audio low battery warning alarm.
Emergency stop located on battery.
Base
Moulded plastic cover at rear of base.
Slip resistant upper surface on the fold up footplate.
The leg position can be altered electrically.
Boom
Padded
Long arc reach
Spreader Bar
Polyurethane coated.
Three hooks at each end.
Push Handle
Wide enclosed push handle mounted from mast.
Drive motor positioned centrally.
Sling Attachment Points
Four attachment points when a stand up sling is used.
Two attachment points are on each side of the handgrip supports.
Control
The hand held control is attached to the hoist with a curly cord and features two speed operation for lift and lowering.
Single handed forward / reverse operation.
Standards
Specific Australian Standards or other Standard(s) may be applicable for materials, manufacturing processes, or installation of some types of equipment. Compliance with relevant Standards is indicated by written certification that a product has been tested and assessed as compliant with specific Standards. Purchasers are advised to check with the supplier or manufacturer of this item as to its compliance with relevant Standard(s).
This hoist meets ISO 10535 standards (information from manufacturer's web site)
Place Of Manufacture
WA Australia