subscribers
A small wrist rest that attaches to a mouse and moves with the mouse. It elevates the forearm, so as to maintain a straight wrist, thus reducing the stress on the wrist tendons. The mouse bean attaches to the mouse using an adhesive strip. It is available in one size only.
A small wrist rest that attaches to a mouse and moves with the mouse. It elevates the forearm, so as to maintain a straight wrist, thus reducing the stress on the wrist tendons. The mouse bean attaches to the mouse using an adhesive strip. It is available in one size only.
To fit the coupling to the mouse:
1. Clean rear of the mouse and the socket flaps with alcohol and let them dry.
2. Choose a flat level surface.
3. Pull the slider out from the hand rest and position it centrally behind the mouse.
4. At the point where the end of the slider touches the mouse, draw a small pencil mark 9mm above the surface of the mouse pad. The mouse may tend to lift if the socket is too low.
5. Apply a few tiny drops of super glue to each socket flap.
6. Carefully align the socket hole over the pencil mark, then press the socket firmly onto the mouse until the glue is set. The adhesive will only reach full strength after a few hours.
7. Pull the slider out from the hand rest and push the end into the socket.
Whilst all care is taken to provide accurate information with respect to the item described, the Independent Living Centre (ILC) is not involved in product design or manufacture, and therefore not in a position to guarantee the accuracy of the information provided. Selection of equipment, which is both suitable and appropriate for individual needs remains the responsibility of the person(s) considering requisition, and no responsibility is taken by the ILC for any loss or injury caused through use of the equipment or alleged to have arisen through reliance upon information provided. As information is subject to change any enquiries should be directed to the manufacturer.
| Supplier | Location | Contact | Website |
|---|---|---|---|
| Ergonomic Office | Fyshwick, ACT | Sales: 1300 555 930 Fax: 1300 666 466 Contact Person: Ann Taylor |
Copyright © 2009 Independent Living Centre NSW.
Site designed by the Human-Computer Interaction Laboratory, School of Computer Science and Engineering, University of New South Wales.
